Does the engraving machine need maintenance

Stone engraving machine is precision CNC equipment, necessary daily maintenance and maintenance of the machine is vital to the service life and accuracy.Please follow the following requirements for maintenance and maintenance.

Maintenance:

I. The continuous operation time shall be less than 10 hours a day to ensure the cleaning of the cooling water and the normal operation of the water pump. In no case should water shortage occur to the water spindle motor. The cooling water shall be replaced regularly to prevent the water temperature from being too high.If the working environment temperature is too low in winter, the water in the tank can be replaced by antifreeze.

2. After each use of the machine, pay attention to cleaning, be sure to clean up the dust on the platform and the transmission system, and lubricate the transmission system (X, Y, Z axis) regularly (weekly).(Note :X, Y and Z triaxial polished rod shall be maintained with oil;Add high speed butter on the lead screw part;If the working environment temperature is too low in winter, the screw rod and smooth rod (square guide rail or circular guide rail) parts should be washed and cleaned with gasoline first, and then the oil should be added, otherwise it will cause too much resistance of the machine transmission part and cause the machine dislocation.

Three, the electrical maintenance inspection is, must cut off the power, until the monitor does not show and the main circuit power indicator lights off, can be carried out.

Maintenance:

Engraving machine parameters modification (Macro system): Manufacturer parameters modification, (enter password :NCSTUDIO click "OK ")

Table travel :(according to machine model)

System parameters: Select the first four items on the default basis.

Motor parameters:

If the three-axis machine is driven by lead screw, if the lead is 10, the motor parameter is 0.00625; if the lead is 5, the motor parameter is 0.003125.If X and Y axes are rack driven machines and Z axes are screw driven machines, the motor parameters of X and Y axes are 0.0098175 and Z axis parameters are determined according to the lead lead of the screw. If the lead is 10, the motor parameters are 0.00625, and if the lead is 5, the motor parameters are 0.003125.

Take-off frequency :300

Z-axis maximum speed :1000

Uniaxial acceleration :400

Curve acceleration :300